Page 1 of 1

Amek Classic missing something

PostPosted: Sun Aug 19, 2018 1:48 pm
by Movbill
Hello everyone !

I'm in France and I restore an Amek console for a month, it works perfectly, a lot of time to clean, change components, it's a good console.
There is a central control module 180, found on the APC1000, in the manual there is little information about automation.
Maybe you can give me an answer to this question:
In the photos, we see connectors fall at the bottom of the console but in the vacuum, some are connected under the faders. What is missing here?
The console had the total of the reminders can be also the dynamic virtual.
Thank you for your help

sorry for my bad English