fader noize

[redpulse]

Hello i have a problem with my 636.

the faders is having a (ground) problem i think,on every channel.
When i use the pots its no problem.
i can record with no hum and noize, but when i play the recorded material ive got this irritating problem on every channel when i use the faders.
where can the broken part be ?
my teory is that it can be the power supply

do you have some tips and tricks please help me

[brianroth]

I am a bit at a loss here....

Is this a "new" problem for the desk, or has is existed since it was installed?

Best,

Bri

[redpulse]

im just installing it now.
from the start i got a problem with the phantom power ,very noizy but my tech solved this with a capacitor i think,
now its lower voltage on phan,
and now its working

can it be the power supply thats needs a restoration?

the problem is when i change on brodcast /tape line
but when im using the knob pot its sounds ok

i have removed all cabels to the ampex 1100

and connected my other backup tascam through line on bantam or was it tape in? and got the returns on volyme pot
and it was working properly.

[brianroth]

Before proceeding any further, measure every power supply rail to ensure the DC voltages are correct. If the voltages seem correct, then use an oscilloscope to ensure there is no "garbage" on the rails.

A "global noise problem" often traces back to a power supply.

If all voltages are correct, and no "garbage" is seen on any rail, report back and we'll dig deeper!

Best,

Bri