by Richard Lumb » Thu Aug 14, 2008 4:12 pm
Hi
The console looks like it was made from different consoles or during the transition phase of new and old logo.
The logo on the picture was current until a couple of years ago.
The C with dot was an original Calrec Logo but changed to the simpler C as part of re-branding around 1991-92.
The Compact was a design completed after the move from AMS.
The earlier ones ran a bit warm.
Lots of facilities in a small space.
EDAC's phase first pin, out of phase second pin, in brackets are screen pins
Odd connectors were the A leg and even the B leg
So VP2 would be for B legs of stereo modules VP3 for A leg of stereo
modules
Mono modules was Mic (A leg)and line inputs (B leg)
Pinout the same for all input EDACs
A.E(B,F,L)
D.K(C,J,P)
M.N(H,T)
R.a(S,W,b)
V.d(U,Z,c)
X.Y(e.f)
k.u(l,p,v)
n.y(m,t,x)
r.s(h,j)
DD.KK(z,EE,LL)
JJ.NN(CC,HH,MM)
AA,BB(FF,w)
VP1 was for Main, aux , LS, Tone, Desk and line outputs
Typical pinout
A.B
C.D
etc.
Screen on pins H,T,w,FF
e,h,f,j not used.
Each module has DIL switches to set insert and direct out puts prefader, post fader or pre EQ.
So unless these are switched out you may not get anything out the desk.
the ANC connector has External MUTEs and VCA control lines and remote start. The RMT led just lights to indicate the fader is open to remotely start a tape machine etc. It pulls low one of the pins from 5v.
Richard