Soundcraft 200B Channel Strips

Founded in 1973, Soundcraft first made its mark with the launch of the Series 1, the first mixing console in a flightcase.

Moderator: GJC Designs

Soundcraft 200B Channel Strips

Postby BlindJack » Sat Feb 20, 2016 11:52 pm

I recently purchased 2 Soundcraft 32-4-2 200B Consoles complete with power supplies and road cases. I was ready to start the ground mod, when I noticed that the PCB traces on the channel board was scratched out in the vicinity of the 20 pin ribbon cable. There are also 2 jumpers that have been soldered onto the bottom of the board. All of the 64 channel strips between these 2 boards have been modified in this way.

My question is whether or not anyone can shed some light on why this was done and what are the benefits if any. The channel strips are all the parametric hi mid and lo mid type.

Thank you in advance.
200B Channel Strip.jpg
Analog Owner
Posts: 1
Joined: Sat Nov 07, 2015 9:53 pm

Return to Soundcraft Recording Consoles

Who is online

Users browsing this forum: No registered users and 2 guests

Mr Patchbay sells patchbays, tt/bantam cables and more